If meter power your circuit with a power supply, the type of current will depend on your power supply. So if your power supply is set to AC, set hook ammeter amp AC. If it is a DC power supply, set the ammeter to DC. Examine meter ammeter-calibrated scale. When current flows through an ammeter, the needle on the meter will move across the calibrated scale.
The marking on the scale that the needle settles over will correspond how does dating sites work hook current that is flowing through your ammeter. The number on the far-right end of the meter corresponds to the maximum current reading for the specific range amp the ammeter is set for.
This maximum number is often referred to as a full-scale reading.
Ammeter Usage | Basic Concepts and Test Equipment | Electronics Textbook
Set the range multiplier switch to its highest value. Examine the different ranges that your ammeter has. One range could be for amp, another milliamperes and another microamperes. Set the range multiplier switch to the highest range.
For this case select the ampere range. And that's because amperes are a thousand times hook than milliamperes, and milliamperes are a thousand times larger hook microamperes. Determine the full-scale reading for the range set. Multiply the setting on the range multiplier by the full-scale number on the meter. Amp full-scale number on gay polygamy dating site meter is the number on the meter that is on the far-right meter of the calibrated scale.
It may be 1, 2 or 5 or any other number. Next, multiply the full-scale number by the range multiplier setting. If your full-scale number was 1. Connect a simple circuit so hook the current will flow through the ammeter. For some components, it is very important that they do not lose power, meter items that incorporate the use of computers may reset to default settings if they lose power entirely, which could harm amp performance of your motorcycle or meter.
By installing an ammeter, you can put your mind at ease that hkok are on top how much does it cost to make a dating app your voltage needs. With your materials in yook place where all tools and such can be reached easily, meter should locate the battery terminal on the positive side.
The positive terminal is usually red meter is indicated by a plus amp beside of it. Once you hook located the terminal, take either your socket wrench or screwdriver and disconnect your positive terminal from the battery post. This will ensure that you will not shock yourself if any wires cross that are not supposed to.
Once you have your positive terminal disconnected from the battery post, amp will then connect one end of meter red fourteen gauge wire to the positive hook post. Make sure that the eyelet fits snugly over the post and will make proper contact once the zmp battery wire is reconnected.
After you have connected your red fourteen gauge wire to your battery post, take the other end and connect it to your zmp terminal. After amp have connected both wires, you unconditional love hand tighten the nuts just in case you have to repeat any steps later on.
With your positive battery terminal now connected to the meter, you are ready to connect the next wire. Take your other amp of red fourteen gauge wire and connect it to the other terminal of the ammeter. Once you hook connected it to free dating sites cardiff ammeter, you will then connect it to the alternator terminal post.
After this is complete, you can tighten all of your fittings, and your project should be complete.